news

Power plug & outlet Type I

Date:2022-08-02   Click:1663   Source:Caron

TYPE I

TYPE I

Type I is mainly used in Australia, New Zealand, Papua New Guinea, China and Argentina. 

This 10 amp plug has two flat 1.6 mm thick blades, set at 30° to the vertical, forming an upside-down V. Their centres are spaced 13.7 mm apart and both prongs measure 17.3 mm in length and 6.3 mm in width. The flat earth blade also measures 6.3 by 1.6 mm, but it is 20 mm long. The distance between the centre of the grounding pin and the middle of the plug is 10.3 mm. There is an ungrounded version of this plug as well, with only two flat V-shaped prongs. Both plug versions have insulated live and neutral pins, so even if the plug is not fully inserted into a socket, touching the exposed part of the prongs can’t give you a shock.

Plugs

A plug/socket configuration rated at 15 amps is also available, but the ground pin is wider: 8 mm instead of 6.3 mm. A standard 10 amp plug will fit into a 15 amp outlet, but a 15 amp plug only fits this special 15 amp socket. There is also a 20 amp plug whose prongs are wider still. A lower-amperage plug will always fit into a higher-amperage outlet but not vice versa. Australia’s plug/socket system is codified as standard AS 3112. Although there are slight differences (the pins of Chinese plugs are 1 mm longer and the sockets are installed with the earth contact facing upwards), the Australian plug mates with the socket used in the People’s Republic of China (mainland China).

The reason as to why the dimensions of the Australian type I are very similar to those of type A is because the Australasian standard is actually an obsolete type of American plug. It was patented in 1916 by Harvey Hubbell II, the same electrical engineer who had invented the type A plug. Hubbell’s three-blade design never proved popular in the U.S. because of its incompatibility with the existing type A plug, but it was favoured in Australia over the British type D system, because it was easier for local manufacturers to make plugs with flat pins rather than round ones. In the 1930s, the predominant Australian electrical accessory manufacturers, along with the State Electricity Commission of Victoria, decided to standardize on Hubbell’s design.

Related News

Low Joule Surge Protector (94J-330J) Applicable Scenarios and Upgrade Suggestions

The Joule Rating of a surge protector directly affects its ability to absorb surge energy. Low-joule (94J-330J) surge protectors are less expensive, but have limited protection capabilities and are suitable for specific scenarios. This article will analyze the applicable devices and provide upgrade suggestions to ensure the safety of your appliances.

Low Joule Surge Protector (94J-330J) Applicable Scenarios and Upgrade Suggestions

Surge Brownout Voltage Protector: How to determine if home appliances are damaged due to a broken neutral line

This article, from the manufacturer of surge brownout voltage protectors, explains how to determine whether home appliances need to be replaced after they are damaged due to a broken neutral wire.

Surge Brownout Voltage Protector: How to determine if home appliances are damaged due to a broken neutral line

Refrigerator Power Surge Protector Factory Talks Neutral Line

Neutral line break is an invisible killer for smart home appliances. It is recommended that smart home users install AVS30 protectors, which have reliable overvoltage protection, fast response, modular design, wide application range, and are economical and efficient.

Refrigerator Power Surge Protector Factory Talks Neutral Line

What is a dual voltage surge protector?

Dual voltage surge protector is a device designed to protect electrical equipment from damage due to voltage fluctuations. It responds quickly when it detects abnormally high or low voltage, cutting off power to prevent damage to the equipment.

What is a dual voltage surge protector?